Firmware / MIB Updates & Downloads
Firmware
Trango provides free firmware upgrades for all products. Each downloadable firmware release package contains the firmware, release notes, and upgrade instructions. Each radio's main firmware version can be found on the System Information page, via the telnet command 'sysinfo'.
More Downloads
Firmware Downloads
To download firmware, click the download ( ) link in the Revision column.
| Point-to-Point |
| Product |
Revision |
Notes |
TrangoLINK-45
P5055M |
v2.0r2 |
Notice: For US and OE models only. For IC models, please use previous revision in archived firmware.
Resolved Issues:
- Improvement to VLAN for management access
- Reset power settings after reboot
- Incorrect result display between Avg dBm and Peak dBm after site survey through HTTP
- Allow administrator to disable auto rate shifting
Enhancements:
- Allow administrator to ignore DFS signal (OE version only)
rdrignore [on|off] - default is off
- "[Elapse]" for DFS's cac in "sysinfo"
- "autoscanmu" for RU
|
ATLAS 5010
P5010M |
v3.0r1 |
New Features:
- Added CLI command to change http port
- Added CLI command to change telnet port
- Changed 5.3 GHz functionality per FCC regulations
Learn More » |
TrangoLINK-10
MU & RU |
v3.1r1 |
Enhancement: Increased upper limit of heater's range |
| Point-to-MultiPoint |
| Product |
Revision |
Notes |
Access5830
AP & SU |
v3.1r1 |
Enhancement: Increased upper limit of heater's range |
Atlas FOX
M5580M-FSU |
v2.0r13 |
Resolved Issues:
- Fix bugs in changing scan table during auto-scan mode or during frequency change
- RSSI LEDs lighted up in opmode off mode
- CLI command showed the incorrect AP to SU Error percentage
- System uptime displaying incorrect time
- CLI testrflink command showed the incorrect received packet count
Enhanced:
- ARQ engine to handle duplicate and out-of-sequence re-transmit packets
- RSSI values when running rssi in CLI
- Association time with access point
|
Fox Series SU
M5800S-FSU
M5800S-FSU-D
M5800S-FSU-D2
M5300S-FSU |
v2.0r2 |
Resolved Issues:
- Not activating opmode after reboot
- Incorrect RSSI values on D2 only
New Features:
- Support ARQ
- D2 only command to adjust power output effecting RSSI values |
Fox Series SU
M5800S-FSU
M5800S-FSU-D
M5300S-FSU |
v05070502 FPGA |
S: AP drops frames/packets from short range SU-Foxes |
M2400S
AP & SU |
v06022101 FPGA |
S: AP/SU: Fixed switching horizontal/vertical polarization. |
M900S
AP & SU |
v2.1r1 |
Resolved issues: AP reboots
Enhanced:
- Rx packets
-SNMP and ARQ
New Feature: Command to disable and enable SNMP engine |
| v0612400 FPGA |
Prevents uploading incorrect firmware between M900S and M915S units |
| M915S SU only |
v2.1r1 firmware &
v0612400 FPGA |
Resolved firmware issues:
- ARQ engine fixed
NOTE: no changes to FPGA --
original file |
SNMP MIBs
Trango provides proprietary Management Information Bases (MIBs) for its products for use with SNMP management programs. To download MIBs, click the download () link in the Revision column.
MIB Packages
|
