Accessories

Data Conversion Board LC485/422

The LC485/422 daughterboard installs into both the Falcon PLUS and Eagle PLUS transmitters and receivers to provide one-way RS-485 or RS-422 transmission. With the LC485/422, the Falcon PLUS or Eagle PLUS can be used to control the pan, tilt, zoom of RS-485 or RS-422 dome cameras (Note: the Eagle PLUS and Falcon PLUS only transmit one direction. Simply adding the LC 485/422 boards will not give you bi-directional serial data and video). This daughterboard is not required when transmitting RS-232.

Dimensions:  1.45" W X 1.5" L X 1.15" H
Connector:  4-position terminal block

Programming Cable CBLDAT-1

The CBLDAT-1 cable is required for programming data pass-through mode on Eagle PLUS and Falcon PLUS systems using TrangoLINK™ software, as well as the SDR900H using SDRLINK software. The CBLDAT-1 can also be used for programming the Access5830 using AP/SU Wizard software. The cable connects to the Trango radio via an RJ11 and to a PC through the 9 pin serial port.

Programming Cable CBLDAT-2 for PTZ-900

The CBLDAT-2 cable is required for programming the PTZ-900 via PC loaded with TrangoLINK™ software. Each PTZ-900* transmitter is supplied with this cable.

Replacement Power Supply PT-9001

This power transformer is supplied with Eagle PLUS, Falcon PLUS, and PTZ-900* transmitters and receivers.

Input:  120VAC, 60 Hz, 10 W
Output:  7VDC, 800 mA